Mataji Electronics

The 79M12 DT is a -12V negative voltage regulator IC that is typically housed in a compact SMD TO-252/DPAK package. It is a member of the 79xx series of fixed linear voltage regulator ICs

The MG82F6D17AE20 is a low-cost, high-performance 8-bit microcontroller (MCU) from Megawin Technology, based on the 1-T 80C51 architecture. This specific model comes in a 20-pin PDIP (Plastic Dual In-line Package), making it suitable for prototyping and through-hole assembly.

The ULN2003 integrated circuit is widely available in surface-mount device (SMD) packages, such as SOIC-16 and TSSOP-16. These variants offer the same functionality as their through-hole counterparts but in a compact form factor for modern PCB designs.

• Usage/ApplicationElectronics
• Mounting TypeDIP
• Part NumberCD4069BD
• TypeLeaded
• Number Of Pins14

• Usage/ApplicationElectronics
• Mounting TypeDIP
• Part NumberCD4069BD
• TypeLeaded
• Number Of Pins14

The International Rectifier IR2101 is a high-voltage, high-speed power MOSFET and IGBT gate driver IC featuring independent high-side and low-side referenced output channels. It is widely used in applications such as motor drives, inverters, and power supplies due to its 600V high-side operation capability

The SN74LS06N is a hex inverter buffer/driver IC with open-collector, high-voltage outputs, while HLF is likely a brand or manufacturer code for integrated circuits,

The Infineon IR2110 is a high-voltage, high-speed power MOSFET and IGBT driver integrated circuit (IC) used in applications such as motor control and power inverters. It provides independent high-side and low-side output channels, enabling efficient control of power transistors in a half-bridge or full-bridge configuration.

The Infineon IR2153 is a self-oscillating high-voltage half-bridge gate driver integrated circuit (IC) used for driving power MOSFETs or IGBTs in power conversion applications. It is an enhanced version of earlier gate driver ICs, designed to be more user-friendly and feature-rich. 

The Infineon Technologies IR2111 is a high-voltage, high-speed power MOSFET and IGBT half-bridge driver integrated circuit used in power electronics applications. It is designed to control both high-side and low-side power transistors with a single input signal. 

The Infineon Technologies IR2113 is a high-voltage, high-speed power MOSFET and IGBT driver IC with independent high-side and low-side referenced output channels, widely used in motor control and power conversion applications.

The 74HCT574D IC is an octal D-type flip-flop with 3-state outputs and TTL-level inputs, available from major online electronics distributors.

The Infineon TLE4208G is an automotive-grade quad half-bridge driver IC primarily used for controlling DC motors in automotive body electronics.

The STMicroelectronics STM32F103C8T6 is a popular 32-bit ARM Cortex-M3 microcontroller (MCU) that operates at 72 MHz and comes in a 48-pin LQFP package. It is widely available for purchase from various online retailers and local stores.

The onsemi MOC3063SR2M is a single-channel, surface-mount phototriac driver optocoupler with a zero-crossing circuit, designed for interfacing low-voltage logic systems with 115/240 VAC lines. Its key feature is the integrated zero-voltage crossing circuit which minimizes electrical noise during AC load switching.

The MOC3052M is an optocoupler integrated circuit designed for isolating low-voltage logic from 115 VAC and 240 VAC lines, enabling random phase control of high-current triacs or thyristors. It is a random-phase (non-zero-crossing) triac driver.

The Nuvoton Technology Corporation M031FB0AE is a 32-bit microcontroller (MCU) based on the Arm® Cortex®-M0 core, operating up to 48 MHz. It is designed for low-voltage industrial and consumer applications and comes in a 20-pin TSSOP package

The N76E003AT20 is an 8-bit, 1T 8051-based microcontroller from Nuvoton Technology Corporation, known for its high performance and rich peripherals, including ADC, PWM, and various communication interfaces. It is widely used in applications such as home automation, motor control, and sensor interfacing due to its wide operating voltage and temperature range.

The Nuvoton MS51FB9AE is an 8-bit microcontroller (MCU) based on the 1T 8051-compatible core, commonly used in embedded systems for applications like home appliances and motor control. It operates at up to 24 MHz and features 16KB of Flash memory and a TSSOP-20 package.

The Nuvoton Technology Corporation M031EC1AE is a 32-bit microcontroller (MCU) based on the Arm® Cortex®-M0 core, designed for industrial control and consumer applications. Key features include a 48 MHz operating frequency, 32 KB of flash memory, and 4 KB of SRAM.

The Infineon 6EDL04I06PT IC is a 600 V three-phase gate driver designed for controlling power switches like MOSFETs and IGBTs in motor drive applications. It uses Silicon-on-Insulator (SOI) technology for robustness against transient voltages and to prevent latch-up

The MJE3055TL is a high-current NPN Bipolar Junction Transistor (BJT) manufactured primarily by Unisonic Technologies (UTC). It is designed for general-purpose switching and power amplification applications, such as motor drivers and power supplies.

The onsemi FL7733AMX is an integrated primary-side-regulated (PSR) LED driver IC with power factor correction, not a typical voltage regulator IC, designed for low-to-mid-power LED lighting converters. It is available for online purchase from various electronic component distributors and can also be found at some local stores in the Bengaluru area.

The 6N139M is a high-speed, single-channel optocoupler featuring a low input current and a high-gain split Darlington output. It is primarily used to provide electrical isolation between low-power logic circuits (like microprocessors) and higher-voltage or noisy environments

The CNY171M is a widely available transistor output optocoupler IC used for providing electrical isolation in various electronic circuits. It is manufactured by companies like onsemi and LITEON and is typically found in a through-hole, 6-pin PDIP package.

The onsemi MOC3023M is a random-phase triac driver optocoupler used for safe, isolated interfacing between low-voltage electronics and high-voltage AC power systems.

The 4N33M optocoupler IC is a single-channel, 6-pin component featuring a gallium arsenide infrared LED and a silicon NPN photodarlington transistor, providing electrical isolation between circuits. It is used in applications like industrial automation, switching power supplies, and logic circuit interfacing.

The onsemi MOC3041SR2M is a single-channel, surface-mount optocoupler IC with a built-in zero-crossing triac driver, designed for isolated control of 115 VAC loads.

The STMicroelectronics NE556N is a dual-precision timer integrated circuit (IC), combining two independent 555 timers in a single 14-pin DIP package. It is widely used for generating accurate time delays or oscillations in various electronic applications. 

The NE555P Integrated Circuit (IC) is a widely used, versatile precision timer in an 8-pin dual in-line package (DIP). It is designed for generating accurate time delays or oscillations in various electronic projects and can operate in astable or monostable modes.

The HT66F003 is a cost-effective, 8-bit high-performance RISC architecture microcontroller (MCU) developed by Holtek Semiconductor. It is specifically designed for applications requiring precise analog-to-digital conversion and low power consumption, such as small household appliances, battery-operated devices, and simple motor controllers

The ICM7555IPA is a low-power CMOS general-purpose timer integrated circuit (IC) that is a direct, improved replacement for the standard NE/SE555 timer in most applications. It is available from several online electronics retailers.

The ILX232D is a dual RS-232 transceiver integrated circuit manufactured by IKSEMICON, designed to facilitate reliable serial communication between TTL/CMOS logic levels and RS-232 compliant devices. It is widely used in microcontroller-based systems, PC interfaces, and industrial automation due to its ease of use and single 5V supply operation.

The Texas Instruments CD4050BE is a hex non-inverting buffer/converter integrated circuit (IC) commonly used for logic-level conversion and as a current driver.